Are you struggling with to update the fimware of your Netgear router failure issue? Millions of Netgear users face the same problem. Therefore, to put an end to your struggle with the Netgear router firmware update failure issue, we have penned up this article. Here, we will provide you various troubleshooting tips that can help you get rid of the issue within a short time. So,what are you waiting for? Let’s get started.
Resolved: Netgear Router Firmware Update Failure
Netgear regularly releases firmware for its WiFi routers to improve their performance and security features. Not only this, various bugs and issues also get fixed by performing firmware update. It can be troublesome if the firmware update itself becomes an issue. Read the following troubleshooting tips to get rid of the issue:
- Reboot Your Netgear Router
Rebooting the router is one of the best ways to resolve hardware and software-related technical glitches. Perhaps, it will also resolve the firmware update issue for you. Follow the steps given below to reboot your Netgear WiFi router:
- Disconnect your Netgear router from all the WiFi devices and unplug it from the wall socket.
- Also, remove the wired connections, if any.
- Now, let your Netgear router stay idle without power for some time.
- Thereafter, plug your router back into the wall socket and turn it on.
Once done, check if the firmware update failure issue resolves. If not, then give the next troubleshooting tip a shot.
- Cross-Check the Firmware Version
Are you sure that you are downloading the correct firmware version for your router? If not, then check it immediately. Sometimes, an incorrect firmware version can also be one of the reasons behind the firmware update failure issue. In addition, it can also affect the performance of your router.
Therefore, it is recommended to upload the correct firmware version for your Netgear router. Besides, do not to run any background tasks on your computer while doing so.
- Check the Internet Connection
Sometimes, a poor internet connection might cause the firmware update failure issue. To check the internet connectivity, run a ping test on your computer. For this, go to the Command Prompt of your computer and type ping 192.168.1.1. Thereafter, press the Enter key. If the Command Prompt responds, it means there is a healthy internet connection. If not, then cross-check the connection between your router and modem. If you have connected both devices wirelessly, use an Ethernet cable to connect them. Ensure that the connection is finger-tight and secure.
If the issue continues, contact your Internet Service Provider to verify if there is an internet issue from his end. If it is, ask him to resolve it as soon as possible.
- Reset and Reconfigure Your Router
Netgear router firmware update failure issue also rises due to improper router installation. Therefore, restore your WiFi device to the factory default settings. Walk through the steps given below to reset your router:
- Power up your Netgear WiFi router and ensure that the power LED is glowing green.
- Now, look for the Reset button on your WiFi device and press it with the help of a pin-like object once found.
- Hold the Reset button for a while before releasing it.
The moment you release the button, your Netgear router will be restored to the factory default settings. Now, reconfigure your WiFi device by accessing the routerlogin.net administrative page on your computer.
After setting up your Netgear router, you need to initiate the firmware process again on your WiFi router.
With the help of the aforementioned troubleshooting tips, you will be able to resolve the ‘Netgear router firmware update failure’ issue. If you liked reading the article, then don’t forget to leave a word of appreciation in the comment section.